Evoko Liso Factory Reset Verified -

: Unplug the USB drive and powercycle the device by removing and reinserting the power cable. Re-registration

Before performing a factory reset on your Evoko Liso device, make sure to:

While holding the button, plug the power source (PoE or DC) back into the device.

After successfully completing the factory reset, the Evoko Liso is entirely blank. Follow these steps to put it back into service:

If a hardware reset fails and the device hangs indefinitely on the logo screen, the file structure on your MicroSD card is likely incorrect. Ensure the files are not nested inside a folder on the card; the bootloader looks for the files directly on the root directory. The Reset Pinhole Button Feels Soft

Ensure the device is receiving consistent Power over Ethernet (PoE) from your network switch.

: Plug the prepared USB drive into the port located on the back of the Liso unit.

Keep your eyes on the touchscreen. If the system reads the boot sector of your recovery disk cleanly, the screen terminal displays this verification statement: "If you do not want to flash the device, remove the USB image and reboot the device, otherwise it will start flash in 30 seconds."

A: While you cannot easily back up a single Liso's configuration, Evoko Home provides tools to back up the entire system's configuration, which includes room and device settings. This backup can then be restored to a new or reset Liso.

Are you encountering any specific on the screen? Share public link

Is your Evoko Liso currently , or is it frozen?

If you still have access to the Admin PIN, this is the cleanest way to wipe the device. Tap the "Admin" button on the Liso screen.

: Once Etcher completes the process and verifies the image, the drive name should change (e.g., "Boot imx6dl"). Ignore any Windows prompts asking to format the drive after flashing. Biamp Cornerstone Execution: Performing the Factory Reset Power Down : Turn off the Evoko Liso by removing its (Power over Ethernet) or power cable. Insert USB