Xta-7000 Temperature Controller Manual -
XTA-7000 Temperature Controller: Complete Configuration & User Manual
The rear terminal arrangement of the XTA-7000 is clearly labeled on the controller’s housing. A typical layout includes:
The XTA-7000 includes multiple alarm functions to alert operators to abnormal conditions. It provides four types of alarm settings: upper/lower absolute value alarm and upper/lower deviation alarm. The controller also includes a comprehensive error detection system. When the controller detects a fault, it will display an error code. xta-7000 temperature controller manual
| | Parameter | Range / Explanation | Default | |----------|-------------------------|--------------------------------------------------------------|-------------| | AL1 | Alarm 1 value | -1999 to 9999 engineering units | 100 | | AL2 | Alarm 2 value | As above | 200 | | AL3 | Alarm 3 value | As above (if model has 3 alarms) | 150 | | Hy | Hysteresis | 0-100°C (prevents output chatter near setpoint) | 1.0 | | P | Proportional Band | 0.1-200.0% (controls aggressiveness; set to 0 for ON/OFF) | 30.0 | | I | Integral Time | 1-3600 seconds (eliminates steady-state error; 0 = off) | 240 | | D | Derivative Time | 0-900 seconds (reacts to rapid changes; 0 = off) | 60 | | At | Auto-tuning | 0 = Off, 1 = On (self-calibrates PID values) | 0 | | Pb | Process high limit | Maximum allowed SV | 400 | | PL | Process low limit | Minimum allowed SV | 0 | | InP | Input sensor type | K, J, R, S, E, N, T, Pt100, Cu50, 0-5V, 0-10V, 4-20mA | K | | Out | Output mode | rL = Relay, SSr = SSR, Lin = 4-20mA | rL | | Ctr | Control type | PID (default) or ON/OFF | PID | | Addr | RS485 address | 1-247 (for Modbus RTU communication) | 1 | | bAud | Baud rate | 2400, 4800, 9600, 19200 | 9600 |
Temperature limits between 0°C to 50°C ( 32∘F32 raised to the composed with power F 122∘F122 raised to the composed with power F The controller also includes a comprehensive error detection
Before diving into programming, proper hardware installation is crucial to ensure accurate readings and safe operations. The
Press the key. The last digit on the SV display will flash. Use the Up/Down arrows to change the value. Press SET to save the new target temperature. Basic Configuration Menu The Press the key
Remember to always refer to the original manufacturer’s documentation that came with your specific model for the most authoritative information on the product.
mode or increasing the deadband (hysteresis) can prevent premature wear on the relay. 6. Where to Find the Official XTA-7000 Manual
Supports various Thermocouples (K, E, J, S) and RTDs (PT100, CU50). Control Methods: PID control or ON/OFF.