Autocraft Battery Charger Ac-60cr Manual

Because this is a manual unit, keeping it on a high-amp setting for too long will boil the liquid electrolyte out of a flooded lead-acid battery.

To estimate how long a battery will take to charge, use this basic equation:

: Provides a temporary high-amperage boost to jump-start a vehicle with a weak battery. images.thdstatic.com Operating Instructions Charging a Battery in the Vehicle Preparation autocraft battery charger ac-60cr manual

Always pull by the plug rather than the cord when disconnecting to prevent damage. 6. Troubleshooting Possible Cause Charger not starting No AC power Check wall outlet and connection. Clips not charging Poor connection/wrong polarity Ensure clips are on correct terminals and clean. LED flashes "Charged" immediately Battery is already full or defective Have the battery tested. Battery not charging Battery is damaged or "dead" The battery may not accept a charge if voltage is too low. 7. Warranty Information

Crank the engine for no more than 5 seconds. If it doesn't start, wait 3 minutes before trying again to prevent the charger from overheating. images.thdstatic.com Safety and Troubleshooting Automatic Battery Charger Because this is a manual unit, keeping it

This information is based on general Autocraft 1.5 amp automatic charger instructions. Always prioritize the physical manual provided with your specific AC-60CR unit.

If you must use an extension cord, ensure it is a heavy-duty, grounded, 3-wire cord rated for outdoor use (minimum 12 AWG or 10 AWG depending on the length) to prevent voltage drops and fire hazards. Troubleshooting Guide 1. The Ammeter Reads Zero (No Current Flowing) LED flashes "Charged" immediately Battery is already full

The battery is severely discharged or has a shorted cell.

Charge the battery at this setting for 3 to 5 minutes to pack a preliminary charge into the cells. Crank the engine for no more than .

2A Trickle, 10A Medium, 35A Fast Charge, and 250A Engine Start. 2. The Built-In Ammeter (Gauge)