Finding the for compatible 3 mil or 5 mil pouches. Providing a step-by-step cleaning guide for the rollers. Comparing this model to newer Staples laminators . Instructions-1171104.pdf - Staples Brand Portal
Once the document exits, place it on a flat surface to cool for a minute before trimming or handling. Maintenance and Troubleshooting Handling Jams
Turn off the power immediately. Press down firmly on the located on the back or bottom of the machine to disengage roller pressure. Manually pull the document back out through the entry slot. The laminated document looks cloudy or hazy. staples 17466 laminator manual
No. Never cut a pouch before laminating. Loose or cut edges will catch on the internal rollers, causing a severe jam. Always laminate the full pouch first, let it cool, and then trim it down to size.
: Users must place their document inside the pouch, ensuring it is centered with at least an 1/8-inch border on all sides for a complete seal. Feeding the Machine : The pouch should always be inserted sealed-edge first Finding the for compatible 3 mil or 5 mil pouches
| Parameter | Value | | :--- | :--- | | Max. Pouch Thickness | 3 mil to 5 mil (0.075mm – 0.125mm) | | Max. Document Thickness | 0.4 mm (excluding pouch) | | Warm-up Time | 3–5 minutes | | Laminating Speed | Approx. 300 mm/min | | Max Operating Temp | 105°C – 125°C (221°F – 257°F) | | Power | 120V AC, 60Hz, 300W (North America) |
Ensure the green light is on; try a slower feed or a thinner pouch. Temperature too high Switch to a lower mil setting or turn off to cool down. Machine Jammed Misalignment Instructions-1171104
: Never use a blade to cut a jammed project off the rollers, as any damage to the roller surface will cause permanent defects in all future laminations.
Remove the laminated item immediately and lay it flat on a cool surface for several seconds to prevent bowing. Cold Lamination
| Problem | Likely Cause | Solution | | --- | --- | --- | | Document wrinkles | Pouch inserted crooked or too fast | Let machine pull straight; wait for green light | | Bubbles / cloudy finish | Pouch too thick (>3 mil) or insufficient heat | Use 3 mil pouches; warm up 5+ minutes | | Machine won’t turn on | Outlet dead or internal fuse | Try different outlet; contact Staples support | | Pouch sticks to rollers | Overheating or empty pouch | Turn off, let cool, clean rollers | | Green light never appears | Thermistor fault | Unplug 30 min; try again or replace unit |