How To Reset Samsung Ml-2165 Printer ❲Ad-Free❳

Try a different USB port (preferably on the back of the motherboard), swap the USB cable, or reinstall the Samsung Universal Print Driver.

button for 10 seconds to print a Configuration and Supplies Information report to find your current firmware version and Serial Number. USB Reset: Some advanced methods involve using a USB flash drive

This is controversial and can break the cartridge if done incorrectly, but it has saved many "empty" cartridges. how to reset samsung ml-2165 printer

A: If the printer locks after a reset attempt, try inserting the original chip or a working original cartridge to see if it can be recognized again. You may need to restart the entire firmware process.

Print a configuration page by pressing and holding the Cancel button for 4 seconds (when ready). Check that settings are default. Try a different USB port (preferably on the

| Problem | Solution | | :--- | :--- | | | Connection issue: The printer wasn't properly connected. Turn the printer off and back on. Wait for it to be ready and run the reset again. | | The printer's lights blink, but it doesn't automatically restart. | Firmware mismatch: The firmware version you are using is lower than the printer's current version. Find a higher version of the firmware and repeat the process. | | The printer restarts but still shows a red light. | Chip not removed: You must remove or disable the chip from the toner cartridge after resetting. Also, check that paper is loaded correctly, as some sensors trigger a red light for paper errors. | | The "replace new cartridge" message still appears. | Software not working: The reset software may not have worked correctly. You may need to find an updated version or use a different tool. | | The printer is not responding at all. | Power issue: Check all power connections. Ensure the printer is receiving power. Also, check that the print job is being sent to the correct port (e.g., USB001). |

Inspect the interior cavity carefully for any tiny scraps of paper or dust buildup near the feed rollers. Clean the metal contact points on the side of the cartridge cavity using a dry, lint-free cloth. A: If the printer locks after a reset

to allow the internal capacitors to drain completely. Reconnect the power and USB cables. Turn on the printer and test a document. 3. Method 2: Clearing the Internal Print Queue

You may need to either replace the chip on the cartridge or use a third-party firmware "fix," though the latter is not officially supported by Samsung/HP and can void your warranty.

All settings revert to factory state. You will need to reinstall drivers and set your preferred paper size.

Plug the power cable back directly into a wall outlet (avoid using unreliable surge protectors during a reset). Reconnect the USB cable to the computer.