Sharp Atomic Clock Spc373 User Manual [exclusive] › [TRUSTED]

However, setting it up correctly requires understanding its specific button functions, signal reception quirks, and battery protocols. This article serves as your definitive user manual.

If you want to force the clock to look for the signal immediately, press and hold the WAVE button on the back of the clock for 3 seconds.

Cycle through the options until your zone appears on the screen: – Pacific Standard Time M – Mountain Standard Time C – Central Standard Time E – Eastern Standard Time 📅 Setting Time and Date Manually

Temperature reading is wrong. Solutions: sharp atomic clock spc373 user manual

While the alarm time is showing, hold the ALARM button until the hours flash. Use UP/DOWN to adjust, then press ALARM to switch to minutes.

Follow these steps to set up your Sharp SPC373 for the first time. Step 1: Battery Installation

Use the (▲) and DOWN (▼) buttons to change the flashing values. Press MODE to confirm each selection and move to the next setting. Step 3: Setting Sequence However, setting it up correctly requires understanding its

If you cannot receive the atomic signal (e.g., remote area, interference), set the time manually.

Setting up your Sharp atomic clock is designed to be largely automatic.

To display the correct atomic time, you must select your specific geographical time zone. Cycle through the options until your zone appears

Pressing the SNOOZE/LIGHT button at any time during normal operation illuminates the blue backlight for 5 seconds for easy night viewing. 🌡️ Additional Features and Preferences 🌡️ Temperature Display

For the atomic synchronization to display the correct hour, you must select your local North American time zone and Daylight Saving Time (DST) preference. Time Zone Selection