Harvey Hv3 Water Softener Installation Manual Direct

Identify the section of the main cold water pipe after the stopcock but before any branches to water heaters or kitchen cold taps.

Ensure the drain line does not travel more than 2 meters vertically or exceed 3 meters in total horizontal length.

Controls soft water leaving the softener into your home.

I can provide specific plumbing configurations for your exact home setup. Share public link

The brine tank is used to store salt, which is used to regenerate the resin in the water softener system. To install the brine tank, follow these steps: harvey hv3 water softener installation manual

Minimum 1.0 bar (14.5 psi) to maximum 6.0 bar (87 psi). A pressure-limiting valve is mandatory if your pressure exceeds 6 bar. Required Tools and Materials Pipe cutter or hacksaw

Assemble and install the three-valve bypass system using appropriate compression or push-fit fittings.

Ensure the location is protected from frost and direct sunlight. Keep the unit within 2 meters of a suitable drain point. Step 2: Main Water Shutoff Turn off the main incoming water stopcock.

The first blocks you load will dissolve rapidly to make up a stock of brine solution. Additional blocks can be placed on top of the first blocks as space becomes available. Identify the section of the main cold water

The unit isn't going through its regeneration cycles.

The Harvey HV3 uses non-electric twin cylinders. Connecting the hoses properly ensures balanced, continuous operation. Step 1: Connect the Inbound and Outbound Hoses Apply plumbing washers to both ends of the flexible hoses.

Harvey HV3 Water Softener Installation Manual: Complete Step-by-Step Guide

Once plumbing is secure, follow these testing procedures to activate the unit. I can provide specific plumbing configurations for your

The salt chamber should never be allowed to drop below approximately 15cm in depth measured from the base of the brine cabinet.

: Includes essential warnings about avoiding heat sources (boilers) and preventing freezing conditions.

This guide provides a comprehensive overview of the installation process to ensure your system runs efficiently from day one. 1. Pre-Installation Checklist

Push the flexible drain hose firmly onto the barbed drain outlet fitting on the back of the softener. Secure it tightly using a hose clamp or clip.