Xnx Universal Transmitter Quick Start Guide [hot] Jun 2026

[ POWER & SIGNAL TERMINALS ] ---------------------------- | 1 | 2 | 3 | 4 | 5 | ---------------------------- | | | | | 24V 0V 4-20mA Common Relay Wiring Steps

This Quick Start Guide provides the essential steps for installing, wiring, and commissioning the XNX transmitter. 1. Pre-Installation Considerations

: The unit features integral mounting tabs for attachment to flat wall surfaces or Unistrut® channels. With an optional pipe mount kit, it can be secured to pipes with diameters ranging from 2 to 6 inches (50 to 150mm).

Before beginning work, confirm the area is non-hazardous and the power source is off.

: For explosion-proof ratings, conduit runs must have a seal fitting within 18 inches (45 cm) of the enclosure. 2. Mounting & Installation Xnx Universal Transmitter Quick Start Guide

The XNX transmitter can be pipe-mounted, wall-mounted, or ceiling-mounted using the integrated mounting lugs. Mounting Steps

Ensure the sensor cartridge (catalytic, IR, or toxic) is appropriate for the target gas.

Mount the transmitter near potential leak sources. Consider gas density (e.g., heavy gases low to the ground, light gases near the ceiling).

If you have the guide and want to create a technical summary or compliance report, here’s a professional structure you can follow: [ POWER & SIGNAL TERMINALS ] ---------------------------- |

Input the exact concentration value of the calibration gas cylinder you intend to use.

Unscrew the enclosure cover and remove the display module to access the terminal blocks.

Use the magnetic wand on the display buttons to navigate the menu. Configuration: Set the gas type and range. Configure alarm setpoints. Configure 4-20mA output parameters.

The XNX supports three main sensor technologies, each requiring a dedicated personality board: With an optional pipe mount kit, it can

This comprehensive guide covers the essential steps for mounting, wiring, configuring, and operating the XNX Universal Transmitter to ensure optimal safety and compliance in industrial environments. 1. Safety and Pre-Installation Checks

Confirm that the attached sensor cartridge matches the target gas, range, and transmitter configuration.

Ensure the package contains the following items:

Before installation, verify the site classification and hazardous area certifications. Ensure all power sources are locked out to prevent electrical shock or accidental ignition in classified areas. Required Tools Hex keys (M5 and M25/M20 locking pins) Flat-head screwdriver (terminal block connections) Open-ended wrench for cable glands Digital multimeter (DMM) Mechanical Installation

Once wiring is verified and the enclosure is securely closed, apply 24V DC power to the unit.

: Approximately 196.85 mm (7.75") wide and 113.8 mm (4.48") deep.