Life Probo Pr70 Instructions For Installation Use And Maintenance Manual 10 Pages Upd -

The PR70 automatically calculates the force required to move the door. This ensures the motor stops instantly if it hits an obstruction.

Life Probo PR70: Instructions for Installation, Use, and Maintenance Manual

Check the rail tension and lubricate the door hinges and rollers (do not grease the rail itself if it is a belt drive).

Hold Bluetooth button 5 sec → reconnect app. The PR70 automatically calculates the force required to

Slide the chain or belt drive tensioner into the designated slot.

Clear obstacles from path; clean lenses; check alignment alignment. Low battery or weak antenna Replace the CR2032 remote battery; extend the antenna wire. Page 10: Routine Maintenance and Warranty Preventative Maintenance Schedule Every 3 Months

: In case of power failure, pull the cord on the mobile trolley to release the motor. To reconnect, move the door manually until it hooks back into the trolley. Hold Bluetooth button 5 sec → reconnect app

Risk of Electric Shock. Disconnect the main power supply before wiring.

For garages that do not have a second access, the ASEC PR device for manual release from outside must be installed.

The Life Probo PR70 Go to product viewer dialog for this item. Low battery or weak antenna Replace the CR2032

Common ground line for all accessory control loops.

Photo-test / NC Safety Contact (Photocell RX signal). Terminal 8: Common ground line.

If you need help with a specific part of the guide, tell me: Which you are currently working on

Hold down the 'RADIO' button continuously for over ten seconds. The indicator LED will turn on solid and then turn off.

: Capable of handling leaf surface areas for doors up to 5 meters wide.