Eliwell Sb655 C Manual

Verify status and polarity of the door switch digital input ( H11 to H14 ).

If the controller behaves erratically due to misconfigured parameters, perform a hard reset:

The Setpoint is the target temperature the controller maintains inside the cold room.

: 5 configurable sensors (NTC, 4…20mA, 0...10V). Digital Inputs : 6 inputs for status or alarm signals. Relays : 6 digital outputs (relays) for system control. eliwell sb655 c manual

Fix: Check system pressures and motor temperatures. Trace the mechanical safety switch resetting mechanism. 7. Factory Reset and Copy Card Programming

The Eliwell SB655 C manual provides detailed installation instructions to ensure proper setup and operation. Key installation steps include:

A: That is not an error. The display is showing that the compressor is in a minimum off-time delay (parameter dLy). It is protecting the compressor from short cycling. The countdown value will appear (e.g., “3” for 3 minutes remaining). Verify status and polarity of the door switch

Press and hold the SET button for more than 5 seconds.

The interface features a 4-digit display and 4 configurable buttons for navigation.

: 5 sensor inputs (NTC, 4-20mA, 0-10V), 6 relay outputs, and 6 digital inputs. Key Functions Digital Inputs : 6 inputs for status or alarm signals

The display will show the first parameter code or prompt you for a password ( PA1 ).

Eliwell SB655 C Manual: Comprehensive Programming and Troubleshooting Guide

: While viewing a value, use UP/DOWN to adjust it and SET to confirm.